Wilo PB-088EA pressure booster pump

Wilo PB-088EA pressure booster pump

Purpose

The pump is designed to increase the pressure in the supply lines.

Description

Pump to increase pressure in an existing line. Small dimensions and weight, design with a "wet rotor", branch pipes in line allow you to mount the pump directly on the pipeline. The flow sensor turns on the pump when there is a flow in the system.
Attention! Automatic operation of the pump is possible when water is supplied to the suction port min. 2 l/min.

materials

Motor and pump have a common stainless steel shaft. The impeller is made of plastic; cast iron pump housing with cataphoretic coating. The pump is equipped with suction and pressure fittings made of bronze (15 mm).

Advantages:

• automatic on/off pump at the beginning / end of water intake (built-in flow sensor);
• does not require the installation of a membrane tank and a pressure switch;
• the pump is easily mounted with studs;
• low noise level;
• three positions of the control switch: manual/auto/off;
• built-in thermal motor protection;
• high corrosion resistance due to a special coating;
• the pump provides a stable constant pressure of water.